Super FAST Brushless Upgrades for 1/10th Electric RC Cars!!!

Share it with your friends Like

Thanks! Share it with your friends!

Close

http://www.nitrorcx.com/1brrcca.html EZRun Series Senor less Brushless Electronic Speed Control ESC + Brushless 10T-3650S- KV 3932 Motor & Program Card w/ 10 Programmable Modes

Comments

Jude Roberts says:

watch out for ezrun brushless 1/10 systems the motor is advertised as 540
size, its actually a 380 size with fins on it, i have fryed 2 of these in
my team associated t3 2 wheel drive, but all the best with your buy and
good video, cheers .

Taylor Chong says:

Is that a RedCat?


Caden Cannon says:

Water proo?

sotajumalaa says:

You should not drain lipos under 3 volts per cell. 3.7 volts per cell is
super conservative. I have used 3.1v per cell as a safe cutoff and never
had any problems.

andrew Fuller says:

I suggest that you upgrade your ESC to a 60 amp because I used a 45 amp ESC
and paired it with a 3 cell lipo battery and ended up shorting out my ESC.
I was left with a melted price of plastic and and burned wires. The exceed
company manufactures the brushless counterpart to the brushed sunfire buggy
and uses a 60 amp ESC. If I wanted completely overkill, I would use a 5900
kv tacon motor, an 80 amp esc, and a 2200 mah sky lipo or gens ace battery.

Xavier Dobson says:

do u think this system will be good for a hpi blitz

njdefily says:

Why did you not remove your old esc when you did the upgrade? 

Epic rc says:

you need a much more powerful system for that 4×4 buggy.. what you have
there is guaranteed heat problems. i had the 65 amp version and with fairly
light gearing also had some excess heat…. good luck man. cool video
though! 

Nathan Esslinger says:

guys just go on ebay and search brushless combo

Armie Abella says:

Brent
Brent
Brent

Redman7806 says:

@Nitrorcx great video! Don’t Forget The Glue :D

STEALTH MAYHEM says:

I would appreciate if you could make me a video on how esc work because I’m
new to brushless cars as I have just purchased a Trojan 1/16 buggy with a
4800kv motor and lipo battery which to my knowledge is super fast. 

Tom Carrick says:

is it he same plug as the one that goes into the receiver to program it?

KpilotRC says:

@nitrorcx thanks i have what rick130 has

GOML46 says:

will it work on any rc car or does it have to be a electric rc car

nitrorcx says:

@smeelokilo At the moment we don’t have thicker axles or axles that’s like
the ones that comes with the Traxxas items. Do you still have the stock
motor on the buggy? The axles should be more than enough to handle the
stock brushless motor that comes with the Sunfire.

cael paps says:

hey im thinking of getting a brushless 1/10 rc car im happy with most of
the fetures but im not to happy on the running time its an 8h charge for
5-10 mins of usage is this true and do you have any tips for me to make it
last longer

Will Powell says:

me and my friend are looking at purchasing a rc car are budget is $400au we
are looking for a 1/10 electric rc care

Rctrail@ction says:

Yo kermit!

Jordan Kraft says:

this will be perfect for my “2WD SLASH” =)))) with a 4000mah lipo!

nitrorcx says:

We have these combos listed online from $84-$94

wayne peeples says:

what fan upgrade do you recommend and what is u opened opinion on foam foam
tires vs rubber on road?

smeelokilo says:

@nitrorcx I ordered new ones and they snapped/bent also :/ Would jumping
the buggy cause this at all? There is a pathway of monkey grass that I like
to jump with the car but it’s not a big jump, maybe 1 1/2 feet of air at
most and I broke an axle shortly after doing this once.

Robert garcia says:

How many did it cost

falconidaes says:

I have 5000mAh 3s Lipo in MT(similar design RC car), and get over 40min(1h
max) of driving. 36x50mm ~500W motor.

Michiel Peetroons says:

3s

smeelokilo says:

@nitrorcx Yes, It is completely stock except for the battery. As stated
above I got a 2 cell 5000mah 20C Lipo for it. I had the ESC cutting off
after 3-4 seconds issue with the stock NiMH battery.

nitrorcx says:

@BashMonkeyRC Good to know, I always set it to 3.2v minimum personally.

REALMRCGOD666 says:

@Ch2is86 nihm battery over 4000 is just as quick as a Lipo and very cheap i
have the set up with a 6500 nihm and tested it with a 2 cell lipo 4600 7.4v
and the nihm had more peak just trim the ESC card to more punch and change
the degree to highest hope this helps

Daniel Johnson says:

i just bought an electric r/c rogster 1:10 buggy and was wondering if it is
any good and alos what size brushless motor would it need?

nelgrump says:

nice !!! im thinking of geting a brushless combo for my driftking

nitrorcx says:

@smeelokilo Is the fronts breaking or the backs? And where are the axles
breaking?

MrTerryTurtle says:

i just brought the ezrun 9t combo for my tamiya gravel hound

zalek swisher says:

is the brushless motor water proof

Ryosaeba8 says:

How to take the motor off?

nitrorcx says:

The combos don’t come with connectors and you have to solder on your own.

Rc-Nerd says:

@sjiyuey thanks ill use them two i think 🙂

GreatWhiteAlex says:

is this waterproof??

DoomKaiserGliders says:

@omarrckzs77 1 10 is bigger than 1 15

nitrorcx says:

Yes you can use a 3S lipo with that combo, but you might want to upgrade
the fan on the ESC later on down the road since the fan isn’t rated for 3s
usage.

Themincraftguy says:

Anybody recommend one that’s under £100 but is fast as f*ck??? Please reply
soon

wmbpounder says:

Man I don’t recommend these cheaper setups by Hobbywing and others. Just
spend the extra money and get the Castle system. This system is like $70.
The castle sidewinder is literally like $20 more. Spend the extra.

Giles M says:

whats the best rc car for under £75? in terms of speed?

Adam Purcell says:

that ezrun motor isnt even a 540 can its a 340 disguised as a 540 as such,
not as fast as a actual 540 motor

Jake Smith says:

Is there some kind of reciever I could hook this motor up to so that i can
just push two buttons whether i want it to go backwards or forwards?

knightrider1545 says:

And zero emissions

rob townsend says:

my 2wd stampede using 32p 17/68 will run between 60-70 kmh. just a rough
guess! haven’t had it hold together long enough to GPS it! lol

MrRolly2009 says:

Hi I have a short course 2 WD rc hell hound and it has a brusless motor .
But I only bought a battery whis las up to 18 min but it’s really fast do u
know where I can get longer lasting batteries? Thanks!

lyleattack says:

@omarrckzs77 its the scale of the car. so 1/4 is a quater the size of the
real thing, 1/10 is 1 tenth the size of the real thing.

redneckalex08 says:

Nice vid. I font normally buy exceed cars. Picked up a drift star and
through a 35amp esc and 4300kv motor on it with a 2s 5000mah 65c gens ace
battery… It rips

Write a comment